Compact to limit spacing between the power tool and torque measurement equipment for improved accuracy and ease of use
The Mountz Mini-RDA Mini Run Down Adapters is designed to be used with low torque sensors to provide consistent and reliable torque readings for power-driven torque control tools. Run down adapters are used to simulate various joint characteristics to provide a more accurate torque reading during testing and calibration.
Mountz Mini-RDA Mini Run Down Adapters allow for an accurate simulation of actual joints. Run-down adapters are mounted in-line between the tool drive and the transducer of a torque analyzer or sensor, reducing the impact and irregular peaks that cause poor testing repeatability.
Kit Contents
- 5 mini RDA units along
- 10 fasteners
Features
- The mini RDA unit with fastener is designed for low torque sensors BMX20z - BMX10i and MTX models
- Designed to provide consistent and reliable torque readings for use with low torque power tools
- The mini RDAs allow a close simulation of actual joints
- Adapter is mounted in-line between tool drive an the torque sensor
- Operates in clockwise direction only
- Provide consistent and reliable torque readings for power-driven torque control tools
- RDA is mounted in-line between the tool drive and the transducer of a torque analyzer or sensor
- Compact to limit spacing between the power tool and torque measurement equipment for improved accuracy and ease of use
- Operates in a clockwise direction only. After each run down, the RDA should be backed-up
Models
| Model | Item # | Screws |
| Mini RDA2 | 061229-2 | PH Phil 2-56 x 1/4 SS |
| Mini RDA4 | 061229-4 | PH Phil 4-40 x 1/4 SS |
| Mini RDA6 | 061229-6 | PH Phil 6-32 x 1/4 SS |
| Mini RDA10 | 061229-10 | PH Phil 10-32 x 1/4 SS |
NOTE:Change screws when thread wear occurs. (Recommended - approximately every 25 run downs). The Mini-RDA unit is not made of Stainless Steel material
Related Products
Downloads
